CNC/ DA-65W SYSTEM ON WINDOWS FUNCTIONS

1. European DELEM multi-axis controller.
2. Display of workpiece profiles in color graphics.
3. Automatic calculation of blank length.
4. Graphical simulation of bending sequences.
5. Display of workpiece profiles before and after bend.
6. Automatic calculation and adjustment of tonnage output.
7. Programmable retract at pinch point.
8. Programmable back gauge delay.
9. Programmable ram speed.
10. Programmable ram dwell time.
11. The ram positioning repeatability is guaranteed by 2 sets of linear scales.
12. Automatic setting of open height and speed change point for each bend.
13. Various angles and bumping bends can be accomplished by the same set of tools.
14. The controller stores up to 999 programs, each contains 17 bend. All programs can be interconnected.
15. Graphic display of punch and die. Data about die sets up to 2MB can be stored.
16. Automatic adjustment of table deflection according to angular tolerance.
17. Precision sectional dies and punches, each marked with length and angle to make tool selection easy.
18. Back gauge travel under 580mm with a speed of 200mm/sec and gauge finger.
19. Programmable R axis (Back gauge height).
20. Multi-language controller, with English, Japanese, Korean, Chinese (traditional & simplified) available.
21. Adoption of German HOERBIGER hydraulic circuit enables independent adjustment of Y1 and Y2.
22. Easy operation with Manual, Automatic and Step-by-Step trial bends modes (by hand wheel).
23. Basic functions ofWindows.
24. USB interface: 2 sets.
25. Switching ON/Off at will.

10.4"LCD